So the cap is present but the steel stick is gone?
It can go anywhere,so don't sweat it.
Yes removing the lower fitting and screen should easily allow remove of a dip stick come loose from the cap.
If it literally does not just fall out... An air line with a long piece of hard tubing, steel... copper...hard plastic, and blow full pressure jets in the tank down near where the stick will be resting, that will rattle that stick around until it falls out.
You could also try a small magnet on a telescope stalk going into the tank from the top from the top or bottom.
It can go anywhere,so don't sweat it.
Yes removing the lower fitting and screen should easily allow remove of a dip stick come loose from the cap.
If it literally does not just fall out... An air line with a long piece of hard tubing, steel... copper...hard plastic, and blow full pressure jets in the tank down near where the stick will be resting, that will rattle that stick around until it falls out.
You could also try a small magnet on a telescope stalk going into the tank from the top from the top or bottom.
Steel.
Also, the dipstick is gone.
I've ordered a replacement.
But do you think that:
a. it won't be an issue if it is in the reservoir
b. might come out when I pull the screen